HANSON RACING TECHNOLOGY



4950 COHASSET ROAD #4
CHICO, CA 95973-9000
USA
530-342-8049 (voice or fax)


CRANKSHAFT SERVICES




ROLLER BEARING CRANKSHAFTS



REBUILD SINGLE CYLINDER CRANKSHAFT * $ 60.00 LABOR

REBUILD TWO CYLINDER CRANKSHAFT * $125.00 LABOR

REBUILD THREE CYLINDER CRANKSHAFT * $180.00 LABOR

REBUILD FOUR CYLINDER CRANKSHAFT * CALL FOR QUOTE

* (PLUS PARTS)

WELD CRANK PINS $ 30.00 EACH


A typical rod kit (per cylinder) includes: connecting rod, big end bearing, crank pin, thrust washers and wrist pin bearing as needed.


HRT will rebuild your crankshaft using parts that you provide or we can supply parts for many models. In some cases, parts of a higher quality than original equipment can be supplied. Please call if this option is of interest.




LIGHTEN AND BALANCE



2 CYLINDER PLAIN BEARING CRANKSHAFT from $250.00

3 CYLINDER PLAIN BEARING CRANKSHAFT from $300.00

4 CYLINDER PLAIN BEARING CRANKSHAFT from $250.00

6 CYLINDER PLAIN BEARING CRANKSHAFT from $300.00

DUCATI BEVEL TWINS from $250.00

GUZZI, BMW, ETC FLYWHEELS from $125.00


Balancing can be done on all crankshafts.


We can lighten or make heavier most crankshafts. Inertia can be increased or decreased at the same or different weight. We can eliminate counterbalance shafts on many engines. Call for information.


Vintage and veteran crankshafts are welcomed. We have been working on crankshafts for over 25 years.




01/01/97

Prices subject to change without notice.


NOTE: Craig Hanson has been doing the cylinder heads and crankshafts in all my race and street bikes for the last 15 years. He is a professional engine developer and I recommend him highly. To see some of the race bikes he's built (including designing and building the frames) check out the photos on the Euro Spares graphics page. You can also read about some of the work he's done on my projects in the articles on the Euro Spares site. - - Michael Moore, Euro Spares


Back to the Euro Spares home page

© 1996 Michael Moore, all rights reserved

Most recent update: 09 March 1997

Hanson Racing Technology is not on line, but if you have any questions about this page (NOT ABOUT HAVING WORK DONE ON YOUR CRANKSHAFT) contact us by using

http://www.eurospares.com/hrt.htm